单轴分布式光纤传感器管线泄漏探测方法及定位理论分析

利用Sagnac干涉原理的分布式光纤传感器是一种可用于长途油气管线侵入、泄漏探测和定位的新技术.为了克服屏蔽和隔离Sagnac光纤环中未用作传感的那一半光纤所带来的屏蔽困难、成本增加等问题，提出一种单轴分布式光纤传感器的方法.其原理是利用一条光纤代替光纤环，并在光纤尾端设置法拉第旋转镜，构成偏振无关Sagnac干涉仪探测和定位管线泄漏.文中详细分析和讨论了该方法的系统光路和探测定位原理.     

吸收式光纤温度传感器的研究

提出了一种利用半导体光吸收谱随温度变化原理设计的半导体吸收式光纤温度传感器.该传感器用GaAs晶片作为温度敏感元件，以光纤作为传光介质，发光二极管作为光源，光电管作为光电转换器件.利用双光束补偿原理,消除了由于光源不稳定产生的干扰.研制出的光纤传感器具有体积小，结构简单，抗电磁干扰，灵敏度高等优点.实验表明:该传感器在－20℃~85℃温度范围内可以达到0.1℃的准确度，可以实现强电磁干扰下的高空飞行器内环境温度的测量.为进一步实现光传飞控系统中的温度测控奠定了基础.     

Fiber-optic reflex sensor for in-line production measurement

The paper describes experiments concerning distance measurement with fiber-optic sensor and improvement of the measurement principle. The sensor probe was well-designed with a small structure and multi-function. The novel optical fiber probe arrangement as well as the possibilities of use for complex measurement problems are explained using the measurement of an internal screw thread as an example. The experimental results show that the measurement uncertainty of the thread minor diameter can reach ±10 μm, and the stability of the measurement system is better than 0.07%.     

用AD590自组数字温度计的设计实验

本介绍了用ADS90自组数字温度计实验，说明了实验步骤和数据处理等过程。     

曲轴箱窜气量检测仪的研制

介绍了车用压差式气体流量传感器的结构设计和电测电路，指出了传感器的使用范围，由实验测出了特性曲线．该仪器可检测车用发动机曲轴箱窜气量，适用于发动机不解体故障诊断．     

用于机械振动实时监测的光纤光栅有源传感装置

把一对中心反射波长分别为1562.11nm和1562.71nm的光纤光栅粘贴在均质、等厚、等腰三角形悬臂梁上下表面作为环形腔光纤激光器端镜，当机械振动激励自由端时，通过观测激光输出脉冲，地施加于自由端的机械振动的频率进行了实时监测；观察两光栅波长漂移量差值的变化，可在0～6.1mm的范围内判断所测振动的振幅。低于100Hz时，实验结果与实际值基本吻合。     

偏振分束器对光学电流传感器稳定性的影响

采用偏振光学理论,详细分析了光学电流传感器中偏振分束器消光比的变化对传感器性能的影响,得到了偏振分束器消光比与传感器输出的关系式,并用系统实验进行了验证.理论及实验结果的吻合证明了光学电流传感器稳定性直接受偏振分束器两路消光比影响的结论.     

甲基对硫磷的快速测定及电化学性质

研究了杀虫剂甲基对硫磷的电化学性质。在pH10．38的Bdtton—Robinson缓冲溶液中，采用微分脉冲溶出伏安法在悬汞电极上得到一个还原峰，峰电位为-0．5V(vs．Ag/AgCl)，本工作对实验条件进行了深入的研究，结合线性扫描伏安法等手段。研究了体系的电化学行为。实验表明，甲基对硫磷在汞电极上具有吸附性，电极反应具有不可逆性。该法用于水果及水样中甲基对硫磷残余量的测定，结果满意。     

Fiber-Optic Chemical Sensor for Detection of NO2 Using Poly (3-Octylthiophene)

A fiber-optic chemical sensor (FOCS) for detection of nitrogen dioxide (NO₂) molecules is reported. The FOCS presents an optropode structure because of the transmission properties of the sensitive material. The NO₂ FOCS is activated by using the semiconductor polymer: regioregular head-to-tail poly(3-octylthiophene-2,5-diyl). The operation wavelength of the sensor is 543.5 nm such that a simple LED and detector can be used for the design of this device. The sensor response decreases after each exposure, demonstrating the reduction in sensitivity as well as irreversibility lower than 5%. However, its properties such as rapid response, high selectivity, high sensitivity (0.43 ± 0.01 muW/ppm), hygroscopic properties, and its operation at room temperature make this kind of FOCS a good alternative for NO₂ toxic gas detection.     

Analysis on Shack–Hartmann wave-front sensor with Fourier optics

In Shack–Hartmann wavefront sensor (SHWS), the behavior of the irradiance pattern produced by the micro-lens array is important for an accurate centroid estimation. In this paper, the behavior of a micro-lens array in SHWS is analyzed using Fourier optics, and reveals that in addition to the main, expected spots, secondary spots with smaller intensities also appeared as a result of diffraction by the small dimensions of the micro-lens and interference from the different micro-lenses. This result is confirmed by comparing with a irradiance pattern taken from an actual SHWS. The additional error in centroid estimation caused by these secondary spots is discussed and relationship to the parameters of the micro-lens of SHWS is analyzed.